Functional Characteristics

1.Layered independent motor drive, adopts scattered-tooth gear box, save more than 20% electricity compared with the traditional gear box

2.To avoid uneven resistance between top and bottom belt, to avoid skid on rubber roller of drive wheel, to avoid top and bottom belt out-of-sync caused by aging canvas belt

3.For traditional double facer, you have to change the both top and bottom belts when replacingbelt. However, normally the bottom belt is still in good condition while the top belt worn out. It will                 become out-of-sync if just change the top belt. For XHL’s master drive, the layered independent drive makes it possible to just replace the top belt

4.The upper / lower roller diameter are both Ф900MM, set high, deep herringbone pattern covered by wearable rubber.

5.Canvas belt guiding roll, our unique design, when the canvas wear and cause slippery, problem can be solved by adjusting the guiding roll, to increase the friction between canvas belt and rubber         roll’s wrap angel, take full advantage of the canvas belt’s service life

6.For the gear box, it adopts independent oil pump with copper pipe distributed in each bearing and each transmission gear to cool down and improve the service life of gear box

7.Quick brake, it takes only 2 seconds to directly stop when hot plates speed at 120m/min. This not only reduce the waste rate, but also saves electricity, production line 150m/min – 300m/min can be     used